In case you haven't been following my quest to make a lowering bracket, here is the thread Making a lowering bracket (lay-down kit). Need some specs... Well I got tired of waiting for the master machinist at the original place that I was going to have it fabbed up at, and decided to move onto a new shop. Since I knew the owner of the new shop (a bike enthusiast himself), we shot the shit for a while and decided to make a mock up out of card board first. To my surprise, less than 24 hours later, he dropped this polished steel beauty at my house. Pretty close considering that the bike wasn't even at his shop!
I'm scheduled to drop off the bike sometime this coming week so they can get exact measurements of the bike and discuss what we can do to improve the original Japanese design in regards to strength. Once we get it on my bike, we'll begin talking about finishes and materials.